CCP+ version 1.02 update notes.

09/10/85
Jim Lopushinsky

1.	The CCP is now no larger than the one supplied with CP/M Plus.
	This has been possible by removing some unnessary code, and
	converting it to Zilog mnemonics and optimizing the code to
	use Z80 instructions wherever possible.  MACRO-80 is now
	required to assemble the CCP and LOADER.  The Loader is now
	1 page smaller than previous versions.  As a result of all
	this, CCP+ will now only run on the Z80.

2.	A library command processor has been added which loads CP/M
	Plus .COM, .SUB and .PRL files from a library called
	COMMAND.LBR.  CMDRUN.COM is invoked by the CCP whenever it
	cannot find the required command.


CCP+ version 1.01 update notes.

02/20/85
Jim Lopushinsky

1.	The comparison of the ZCPR variable MAXDRV is now properly
	adjusted.  Previous versions assumed 1=A, 2=B, etc.   It has
	now been corrected so that 0=A, 1=B.

2.	On cold boot, the ZCPR variables are initialized as follows:
	MAXDRV = 15 (Drive P:)
	MAXUSR = 16 (User 15)
	WHEEL  = 0FFH (enabled)